Download Print this page

Safety Information & Warnings - NewAir WAT10W Owner's Manual

Water bottle filtration system

Advertisement

SAFETY INFORMATION & WARNINGS
Please keep the filter core out of the reach of children. Never allow a
child to play with the filter
 The filtration system is not intended to disinfect water. Never use water that
is microbiologically unsafe or of unknown quality without adequate
disinfection before or after using the filtration system.
 If the filter core is not cleaned thoroughly, some active carbon powder may
flow out along with the water; blocking the filter core. To ensure water
quality, it is recommended that the filter core not be installed for initial use
until after one bottle of water is filtered.
 Change the filter core every 6 months for healthier, great-tasting water.
 This product requires ambient temperatures of 50-100° F and must be kept
out of direct sunlight.
 This filter is used with tap water. Water quality can vary with region and
poor water quality may affect the service life of the filter core and the
quality of water dispensed.
 If this filter is not used for more than one week, rinse and air dry the filter
core for sealed storage. To use again, simply clean and replace the filter
core. Improper storage may cause an odor. If this occurs, we recommend
replacing the filter core.
 During usage, if the water level in the lower barrel is higher than that of the
upper barrel, the filtration speed may decrease or stop. This is not a
malfunction and will correct itself.
 After adding water, water cannot flow out of the filter core for some time
until trapped air is gone. This is not a malfunction. If only a little water
comes out, remove the filter core and replace it.
 While cleaning, please keep the filter core sealing gasket properly attached.
Failure to do so may cause water leakage and thus affect water quality.
 When replacing the filter core, we recommend rising out the entire water
filtration system.
4
http://www.NewAir.com

Advertisement

loading