Cancelling A Program; Switching The Machine Off - Sharp QW-NI13I49EX-EN User Manual

7.2. Cancelling a Program

Follow the steps below to cancel
a program while in operation.
When the door of your machine is
opened, the light corresponding
to the most recently selected
program will illuminate.
Press and hold the Program Selection
button for 3 seconds. The End Of
Program Indicator will flash and the
program light will switch off.
The water discharge process will start
after the door of the machine is closed
and will continue for 30 seconds.
A buzzer will sound 5 times when a
program is cancelled and the End Of
Program Indicator will illuminate.

7.3. Switching the Machine Off

The End Of Program Indicator will illuminate when a
program is complete. A signal will also sound 5
times. You can then switch your machine off using
the Power On/Off button.
Disconnect the plug and turn off the
water tap.
NOTE: Do not open the door before the
program is complete.
NOTE: If the door of the machine is
opened or the power is cut off while a
program is in operation, the program will
continue when the door is closed or the
power returns.
NOTE: If the power is cut or the
machine door is opened during the drying
process, the program will terminate. Your
machine will now be ready for a new
program selection.
Buzzer Sound Control
To change the buzzer sound level, follow
the below steps:
1. Open the door and press Program and
Half Load (3) buttons simultaneously for 3
seconds.
2. When sound setting is recognize buzzer
gives a long sound and machine will
display last set level, from "S0" to "S3".
3. To decrease sound level press
Program (2) button. To increase sound
level, press Half Load (3) button.
4. When voice level is change
corresponding leds shown below table
illuminate.
Voice
Levels
1/2
S0
S1
S2
S3 X
5. To save the selected sound level, turn off
the machine.
''S0'' level means all voices are off. Factory
setting is "S3.
Save Power Mode
To activate or deactivate save power mode,
follow the below steps:
1. . Open the door and press Half Load (
and Delay (4) buttons simultaneously for 3
seconds.
2. After 3 seconds, the machine will display
last setting.
3. . When Save Power Mode is activate
P1, P2, 1/2 leds illuminate. On this mode,
interior lights will turn off 4 minutes after the
door is opened, and the machine will turn
off after 15 minutes of no activity in order to
save energy.
4. . When Save Power Mode is deactivat
P1, P2 leds illuminate. If Save Power Mode
is deactive, interior lights will be on as long
as the door is open, and the machine will
always be on unless it is turned off by user.
EN - 18
Leds
3h 6h 9h
X
X X
X X X
X X X