Troubleshooting - Sharp QW-NI13I49EX-EN User Manual

The installation and repairing procedures should always carried out by the Authorised
Service Agent in order to avoid possible risks. The manufacturer shall not be held liable
for damages that may arise from procedures carried out by unauthorised persons. Repairs
may be carried out by technicians only. If a component has to be replaced, ensure that only
original spare parts are used.
Improper repairs or use of non-original spare parts may cause considerable damage and
put the user at considerable risk.
Contact information for your customer service can be found on the back of this document.
Function-relevant genuine spare parts according to the corresponding Ecodesign order can
be obtained from Customer Service for a period of at least 10 years from the date on which
your appliance was placed on the market within the European Economic Area.
FAULT
Whitish stains remains
on dishes.
Dishes do not dry.
Rust stains form on the
dishes.
Detergent remains in the
detergent compartment.
POSSIBLE CAUSE
Not enough detergent used.
Rinse aid dosage and/or water
softener setting set too low.
High water hardness level.
Salt compartment cap not closed
properly.
Drying option is not selected.
Rinse aid dosage set too low.
Stainless-steel quality of the dishes
is insufficient.
High level of salt in wash water.
Salt compartment cap not closed
properly.
Too much salt spilled in the
Dishwasher while filling it with salt.
A poor mains grounding.
Detergent was added when the
detergent compartment was wet.
EN - 23

TROUBLESHOOTING

Use the correct amount of detergent,
as instructed in the program table.
Increase rinse aid and/or water softener
level.
Increase water softerner level and add salt.
Check that the salt compartment cap is
closed properly.
Select a program with a drying option.
Increase rinse aid dosage setting.
Use only dishwasher-proof sets.
Adjust the water hardness level using water
hardness table.
Check that the salt compartment cap is
closed properly.
Use funnel while filling salt to the
compartment to avoid spillage.
Consult a qualified electrician immediately.
Make sure detergent compartment is dry
before use.