Table of Contents
Advertisement
⑭ Data logger symbol
3.
BUTTONS
1) Laser/Backlight on/off button
2) Up button (for EMS,HAL,LAL)
3) Down button (for EMS,HAL,LAL)
4) MODE button (for cycling
through the mode loop)
Functional Design
1.
When measuring , press MODE keys to display
MAX value, MIN value, DIF value , AVG value, LOG
value.
2.
If the TYPE-K thermocouple is not connected, you can
adjust EMS by pressing up/down key.
3.
In the HOLD mode, you can adjust C/F by pressing
up/down key
4. You can turn on/off the backlight/laser by pressing
LIGHT/LASER key at any state.
5. To set values for the High Alarm (HAL), Low Alarm (LAL)
and Emissivity (EMS), press the MODE button until the
appropriate code appears in the display, press the UP
and down buttons to adjust the desired values.
MODE Button Function
In the HOLD mode, Pressing the mode button also allows
you to access the set state, MAX MIN DIF AVG LOG
display, Emissivity(EMS),Lock on/off,HAL on/off, HAL
adjustment, LOW on/off,LOW adjustment,C/F Each time you
press set you advance through the mode cycle. The diagram
shows the sequence of functions in the mode cycle.
3
4
9
1
2
Advertisement
Table of Contents
