Table of Contents
Advertisement
location.
4.Log Clear Function
The "Log clear" function allows you to clear all logged data
points. This function can only be used when the unit is in
LOG mode. It can be used when the user has any number of
LOG locations stored.
You should only use the LOG clear function if you want to
clear all the Log location data that is stored in unit's memory.
The "LOG clear" function works as follows:
(1) While in LOG mode, press the trigger, and then press the
"down" arrow button until you reach LOG location "0".
Note:
This can only be done when the trigger is pulled. LOG
location "0"cannot be accessed, by using the "up" arrow
button.
(2) When LOG location "0" is present on the display, press
the laser/backlight button. You will hear a tone, and the LOG
location will automatically change to "1", signifying that all
data locations have been cleared.
USB Function
This device affords transmitting the IR and Type K
measurement data to the PC via USB.
Turn on or Shut off USB function:
Under MAX/MIN/DIF/AVG state, press LIGHT/LASER button
until "USB" sign appears in the right lower corner of the LCD.
the USB function will turn on.
11
Advertisement
Table of Contents
