Download Print this page

Hi-Z Antennas AL-18 Assembly Instructions

Vertical

#2 from R –AL-18

Right Most – AL-23

Hi-Z Antennas™ Models AL-18, AL-23 Vertical Assembly Instructions – pg 1/3

L to R: .875, .750, .625 &

.500 (AL-23 ONLY)

Please read and familiarize yourself with these Instructions before starting

assembly. Also verify you have all the parts.

WARNING: Avoid HAZARDOUS LOCATIONS. Stay Clear of Power Lines

And or any overhead obstructions.

HF RECEIVING

Fig 1

Fig 3

HIGH PERFORMANCE

SYSTEMS & COMPONENTS

Fig 4

Table of Contents

Need help?

Do you have a question about the AL-18 and is the answer not in the manual?

Page 1 Hi-Z Antennas™ Models AL-18, AL-23 Vertical Assembly Instructions – pg 1/3 L to R: .875, .750, .625 & Fig 1 .500 (AL-23 ONLY) Fig 4 Fig 3 Please read and familiarize yourself with these Instructions before starting assembly. Also verify you have all the parts.
Page 2 Locate the two each 8” wires and Red Terminals (4ea). Strip all four ends and crimp on the 4 Red terminals. Option: solder each terminal. For AL-18 – locate the 3 tubes; .875, .750 and .625 diameter, use the 2 smaller SS clamps to clamps the 3 tubes at the 2 overlap points.
Page 3 ~55-60pf. This will allow the Hi-Z Amp to produce from 2-3db higher gain and therefore increasing system performance. As well as increasing the physical spacing of the element from the base mount. Antenna terminal to Hi-Z ©2011 Hi-Z Antennas™...

Al-23