General; Location Of Controls; Connections - Sony CDX-GT572 Service Manual

• LOCATION OF CONTROLS

Location of contr o ls and basic operations
Main unit
1 2 3
OFF
ALBM
SOURCE
SEEK SEEK
ALBM
MODE
BTM
PUSH SELECT
7 8 9 q; qa qs
Front panel removed
qg
RESET
Card remote commander
RM-X151
wa
1
OFF ATT
ws
3
SOURCE SEL MODE
q;
qk
+
wd
–
ql wf
DSPL SCRL
1 2 3
wg
4 5 6
+
w;
VOL
–
6

• CONNECTIONS

A
SUB OUT (MONO)
B
BUS AUDIO IN
BUS CONTROL IN
SECTION 2
4 5 6
OPEN
AUX
REP SHUF PAUSE SCRL
1 2 3 4 5 6 DSPL
qd qf
qh qj
This section contains instructions on the location
of controls and basic operations. For details, see
the respective pages.
For optional device (CD/MD changer, etc.,)
operation, see "Using optional equipment" on
page 10. The corresponding buttons on the card
remote commander control the same functions as
those on the unit.
A OFF button
To power off; stop the source.
B Volume control dial/select button
page 9
To adjust volume (rotate); select setup items
(press and rotate).
C SOURCE button
To power on; change the source (Radio/CD/
AUX)*.
D Display window
E AUX input jack page 10
To connect a portable audio device.
FRONT
AUDIO OUT
REAR
AUDIO OUT

GENERAL

F OPEN button page 5
G ALBM +/– buttons (during MP3/WMA
playback)
To skip albums (press); skip albums
continuously (press and hold).
H Receptor for the card remote
commander
I SEEK –/+ buttons
CD:
To skip tracks (press); skip tracks
continuously (press, then press again within
about 1 second and hold); reverse/fast-
forward a track (press and hold).
Radio:
To tune in stations automatically (press); find
a station manually (press and hold).
J MODE button page 8
To select the radio band (FM/MW/SW)*.
K BTM button page 8
To start the BTM function (press and hold).
L Frequency select switch (located on the
bottom of the unit)
See "Frequency select switch" in the
supplied installation/connections manual.
M Number buttons
CD:
(3): REP page 8
(4): SHUF page 8
(6): PAUSE
To pause playback of a CD on this unit.
To cancel, press again.
Radio:
To receive stored stations (press); store
stations (press and hold).
N DSPL (display)/SCRL (scroll) button
page 8
To change display items (press); scroll the
display item (press and hold).
O RESET button page 4
P Z (eject) button page 5
To eject the disc.
Q Disc slot page 5
To insert the disc.
Connection example
Notes (2- A )
• Be sure to connect the ground (earth) lead before connecting
the amplifi er.
• The alarm will only sound if the built-in amplifi er is used.
Tip (2- B)
When connecting only a single CD/MD changer or other optional
device, connect directly to this unit.
Ejemplo de conexión
Notas (2- A )
• Asegúrese de conectar primero el cable de conexión a masa
antes de realizar la conexión del amplifi cador.
• La alarma sonará solamente si se utiliza el amplifi cador
integrado.
Sugerencia (2- B )
Cuando conecte un solo cambiador de CD/MD u otro dispositivo
opcional, hágalo directamente a esta unidad.
CDX-GT572
This section is extracted
from instruction manual.
The following buttons on the card remote
commander have also different buttons/functions
from the unit. Remove the insulation film before
use (page 4).
qk < (.)/, (>) buttons
To control CD/radio, the same as (SEEK)
–/+ on the unit.
Setup, sound setting, etc., can be operated by
< ,.
ql DSPL (display) button
To change display items.
w; VOL (volume) +/– button
To adjust volume.
wa ATT (attenuate) button
To attenuate the sound. To cancel, press
again.
ws SEL (select) button
The same as the select button on the unit.
wd M (+)/m (–) buttons
To control CD, the same as (ALBM) +/– on
the unit.
Setup, sound setting, etc., can be operated by
M m.
wf SCRL (scroll) button
To scroll the display item.
wg Number buttons
To receive stored stations (press); store
stations (press and hold).
* In the case of a CD/MD changer being connected;
when ( SOURCE) is pressed, the connected device
("MD") will appear in the display, depending on
which device is connected. Furthermore, if (MODE)
is pressed, you can switch the changer.
Note
If the unit is turned off and the display disappears, it
cannot be operated with the card remote commander
unless (SOURCE) on the unit is pressed, or a disc is
inserted to activate the unit first.
7
5