GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover on the back of
the unit, use a screwdriver to loosen
the screw and then open the battery
box.
3. Remove old batteries by pulling
up on one end of each battery.
4. Install 2 new AA (AM-3/LR6)
batteries following the diagram
inside the battery box. (For
best performance, alkaline
batteries or fully charged Ni-MH
rechargeable batteries are
recommended).
5. Replace the battery cover and
tighten the screw to secure.
Note: If there is no response when the dino is switched on,
please install brand new batteries and try switching the dino on
again.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach
of
children.
4