Note – This section is only required if the Norbar torque wrench is being utilised.
WARNING – The SM-FT-1000 tool range is not suitable for Smart
the maximum torque settings recommended for the Smart
Recommended Torque Settings
*IMPORTANT – From July 2019 a new low torque drive system has been incorporated into the tool giving lower torque
settings than previous tools*
Smart
Tie
®
Size
Material
PA66 (Nylon 6.6)
PA12 (Nylon 12)
20mm (¾˝)
PK
PPS
PA66 (Nylon 6.6)
PA12 (Nylon 12)
32mm (1¼˝)
PK
PPS
Smart
Band Hybrid & Smart
Band Compact
®
®
Size
Buckle Material
PA66 (Nylon 6.6.)
PA12GF (Nylon 12 Glass-filled)
19mm (¾˝)
PPS
POM (Acetal)
PA66 (Nylon 6.6.)
PA12GF (Nylon 12 Glass-filled)
32mm (1¼˝)
PPS
POM (Acetal)
The input torque in the table above is the maximum recommended torque around a cylindrical application. This may need to be reduced depending on the following:
1
- An irregular shaped application, e.g. an application that has sharp corners around its profile
- An application in high ambient temperatures and direct sunlight, where the temperature of the Smart
- An application where the Smart
w w w.h clfaste ne rs . com
Diameter
mm
100
200
Band Material
PA66 (Nylon 6.6.)
PA12GF (Nylon 12 Glass-filled)
PPS
POM (Acetal)
PA66 (Nylon 6.6.)
PA12GF (Nylon 12 Glass-filled)
PPS
POM (Acetal)
Band buckle is suspended in mid-air, i.e the buckle is not supported underneath