Advertisement
INSTALLATION
Install the Bidet
1. Install the services.
2. Make sure that the hot and cold
water supply pipes and the waste
are installed correctly.
Note!
The hot and cold water supplies
must be installed with isolating valves.
3. Place the fixing bracket against the
wall, and mark the positions of the
fixing holes on the wall.
Caution!
Make sure that you
avoid hidden cables and pipes
when drilling holes in the wall.
4. Drill the fixing holes, and insert the
wall plugs into the drilled holes.
5. Secure the fixing bracket to the wall
using suitable screws.
6. Fit the tap to the bidet in
accordance with the manufacture , s
instructions.
7. Fit the clamping assembly inside
the bidet and hold in position with
the fixing screw.
8. Fit the waste and connect the tap to
the hot and cold water supplies.
9. Positon the bidet against the wall.
10.Make sure that the clamping
assembly locates under the fixing
bracket on the wall.
11. Use a level to ensure the bidet is
level and is instaaled in the correct
position.
12. Ensure that all the connections are
tight.
13. Use an hexagonal wrench to
tighten the screw on the clamping
bracket assembly, and fit the cover
cap over the screw head.
14. Apply silicone sealant around the
top, sides, and base of the bidet.
1037581-T01-A
m m
1 1 0
35 mm
m m
1 0 0
250mm
100 mm
120 mm
Clampig Assembly
6 mm
250 mm
-3-
1.
2.
3.
P4137020
4.
5.
6.
7.
P4137030
8.
9.
P4137040
10.
11.
12.
13.
P4137050
14.
Advertisement
