Download Print this page

Graco 307133P Instructions-Parts List Manual page 5

2.5 gallon pressure tank

Advertisement

Fig 2
For Dual
Regulated
Tank Only
12
16
11
Air Atomizing
Regulator If Dual
Regulated Tank
10
Air to Gun If Dual
Regulated Tank
Fig 3
Installation
A
9
Refer to Fig 3
B
C
D
E
FLUID
AIR
7857
For Single and Dual
Regulated Tanks
Inlet
Port
All
other
ports
9b
outlet
9a
9d
Air To Tank
9d
Air From Compressor
9e
Air To Gun If Single
Regulated Tank,
Or
Air To Atomizing
Regulator If Dual
Regulated Tank
7858 rev
About the single-regulated tank (Model 171226)
When the air pressure to the tank and the spray gun at-
omizing air are controlled by one regulator, the same
pressure is delivered to both.
About the dual-regulated tank (Model 223883)
For separate control of the atomizing air, a separate at-
omizing air regulator for the tank is supplied. See To add
an air atomizing regulator, below.
NOTE: Use thread sealant on all male threads.
All tanks
Install an air filter upstream from the regulator to remove
dirt and moisture from your air supply.
Screw the riser tube (E) into the pipe fitting on the bottom
side of the tank cover. See Fig 1.
Single-regulated tank
Assemble the air regulator (9) as shown in Fig 2. Screw
the regulator assembly into the port marked AIR on the
tank cover.
Screw the handle (A) and the nut (C) onto the cover, and
tighten them securely. See Fig 1.
Connect an air supply hose to the 1/4 npt air inlet nipple
(9d). Connect the gun's air atomizing hose tee fitting (9e).
Connect the gun's fluid hose to the adapter (D), at the
point marked PAINT. See Fig 1.
To add an air atomizing regulator
Remove the handle (A) and nut (C). Remove the tank
regulator assembly (9) and assemble the second regu-
lator to it as shown in Fig 2.
Screw the dual regulator assembly into the tank cover
port marked AIR. Reinstall the handle (A) and nut (C).
9c
Connect the air supply hose to the nipple (9d). Connect
gun's air atomizing hose to the nipple (10). Connect the
gun's fluid hose to the adapter (D), at the point marked
PAINT. See Fig 1.
Install the gun
Connect the air atomizing and fluid hoses to the gun. See
Fig 1.
Grounding
Ground the sprayer as instructed on page 3 before oper-
ating it.
307133
5

Advertisement

loading