Advertisement
Quick Links
Instructions – Parts List
2.5 Gallon Pressure Tank
(Non–ASME Design)
50 psi (350 kPa, 3.5 bar) Maximum Working Pressure
Part No. 171226, Series C (shown)
Basic portable pressure tank
Part No. 223833
with Dual Regulators
Important Safety Instructions
Read all warnings and instructions in this manual.
Save these instructions.
307133P
EN
Advertisement
Summary of Contents for Graco 307133P
- Page 1 Instructions – Parts List 2.5 Gallon Pressure Tank 307133P (Non–ASME Design) 50 psi (350 kPa, 3.5 bar) Maximum Working Pressure Part No. 171226, Series C (shown) Basic portable pressure tank Part No. 223833 with Dual Regulators Important Safety Instructions Read all warnings and instructions in this manual.
- Page 2 D This equipment is for professional use only. D Read all instruction manuals, tags, and labels before operating the equipment. D Use the equipment only for its intended purpose. If you are uncertain about usage, call your Graco distributor. D Do not alter or modify this equipment. Use only genuine Graco parts and accessories.
- Page 3 WARNING PRESSURIZED EQUIPMENT HAZARD Spray from the gun, hose leaks, or ruptured components can splash fluid in the eyes or on the skin and cause serious injury. D Do not stop or deflect fluid leaks with your hand, body, glove, or rag. D Follow the Pressure Relief Procedure on page 6 whenever you: are instructed to relieve the pressure;...
- Page 4 Installation Grounding 5. To maintain grounding continuity when flushing or relieving pressure, always hold a metal part of the gun firmly to the side of a grounded metal pail, WARNING then trigger the gun. FIRE AND EXPLOSION HAZARD Before operating the pump, ground the system as explained below.
- Page 5 Installation About the single-regulated tank (Model 171226) When the air pressure to the tank and the spray gun at- omizing air are controlled by one regulator, the same pressure is delivered to both. Refer to Fig 3 About the dual-regulated tank (Model 223883) For separate control of the atomizing air, a separate at- omizing air regulator for the tank is supplied.
- Page 6 Operation Pressure Relief Procedure WARNING WARNING To reduce the risk of serious injury whenever you are instructed to relieve pressure, always follow the INJECTION HAZARD Pressure Relief Procedure on page 6. Fluid under high pressure can be in- jected through the skin and cause serious injury.
- Page 7 Operation Adjusting the air regulators Pour a compatible solvent into the tank. WARNING CAUTION To reduce the risk of overpressurizing the tank, Be sure the solvent you use is compatible with the which could result in component rupture and cause fluid being sprayed and the hose material.
- Page 8 Parts not visible 7860 rev Model 171226, Series C Basic Pressure Tank with Single Regulator No. Part No. Description Includes items 1–9 214979 REGULATOR ASSEMBLY Model 223833 Includes items 9a–9e with Dual Regulators 9a 100139 . PLUG, 1/8 npt Includes items 1–12, 16 9b 104655 .
- Page 9 Technical Data Tank capacity ......... 2.5 gallons (9.5 liters) Maximum working pressure .
- Page 10 With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.