Introduction; Scope; Target Group; Disclaimer - XEMEX DINgate DSO User Manual

1 Introduction

1.1 Scope

This manual is applicable to DINgate DSO, a communication gateway for the ABB B21/B23 E-meter family.
It describes the specifications, installation and operation of the product. Please read this document carefully before
installation and operating.

1.2 Target group

The installation and the operation of this device and any maintenance must be carried out by a qualified person in
accordance with specific local standards and safety regulations.

1.3 Disclaimer

The information in this document is subject to change without notice and should not be construed as a promise by
Xemex. Xemex assumes no liability for possible errors in this document. In no event shall Xemex be liable for direct,
indirect, special, incidental, or consequential damages of any kind arising out of the use of this document, nor shall
Xemex be liable for incidental or consequential damages arising out of the use of this document, described software
or hardware.

1.4 Applicable product versions

This manual is applicable for following product versions:
Product version
DINgate 1.0 – DSO
DINgate 1.1 – DSO

1.5 Intended usage

The DINgate DSO module can only be used in combination with the ABB B21/B23 E-meter family and shall operate
within the specified values only.

1.6 Technical assistance

In case technical assistance is needed, contact Xemex NV:
XEMEX NV
Metropoolstraat 11a
B-2900 Schoten
Belgium
Tel: +32 201 95 95
E-mail: support@xemex.eu

1.7 Used symbols

Following symbols are used in this document and/or are marked on the product:
Alternating current
01 October 2021
Description
4G Cat-1 with GPRS fallback communication gateway for ABB B21/B23 E-meters
4G Cat-M communication gateway for ABB B21/B23 E-meters
XEMEX Confidential
User Manual - DINgate DSO
Page 5 of 16