TROUBLESHOOTING
Symptom
Ram will not lift load
Ram *bleeds off after lift
Ram will not lower after unloading
Poor performance
Will not lift to full extension
* "Bleeding off" means that jack begins to slowly lower rather than keep load at height.
For a period of one (1) year from date of purchase, KTI, will repair or replace, at its option, without charge,
any of its products which fails due to a defect in material or workmanship, or which fails to conform to any implied
warranty not excluded hereby.
Performance of any obligation under this warranty may be obtained by returning the warranted product,
freight prepaid, to K-Tool International 31111 Wixom Rd. Wixom, MI 48393, phone (248)669-5000.
Except where such limitations and exclusions are specifically prohibited by applicable law. (1) the
CONSUMER'S SOLE AND EXCLUSIVE REMEDY SHALL BE THE REPAIR OR REPLACEMENT OF DEFECTIVE
PRODUCTS AS DESCRIBED ABOVE, and (2) KTI SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL OR
INCIDENTAL DAMAGE OR LOSS WHATSOEVER, and (3) THE DURATION OF ANY AND ALL EXPRESSED AND
IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION, ANY WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE, IS LIMITED TO A PERIOD OF ONE (1) YEAR FROM DATE OF
PURCHASE.
Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not
apply to you. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.
Possible Causes
•
Release valve not tightly closed
•
Overload condition
•
Release valve not tightly closed
•
Hydraulic unit malfunction
•
Reservoir overfilled
•
Linkages binding
•
Fluid level low
•
Air trapped in system
•
Fluid level low
ONE YEAR LIMITED WARRANTY
5
Corrective Action
•
Ensure release valve tightly closed
•
Remedy overload condition
•
Ensure release valve tightly closed
•
Replace Ram and / or Pump
•
Drain fluid to proper level
•
Clean and lubricate moving parts
•
Ensure proper fluid level
•
With ram fully retracted, remove oil filler
screw to let pressurized air escape,
then reinstall oil filler screw
•
Ensure proper fluid level
KTI-63705-M0