Advertisement
BEFORE USE
(refer to Figure 1)
1. Inspect before each use. Do not use if bent,
broken, leaking or damaged components are noted.
2. Ensure that product and application are compatible.
3. Check to ensure that all parts of your kit are
included (see illustration and parts list).
4. Carefully remove the dust caps and plugs from hose
coupler and ram coupler.
5. Connect hose coupler to ram coupler, ensure that
there are no fluid leaks.
6. Locate and open release valve. Pump handle a few
strokes to purge air from system. Close release
valve and pump handle until ram is fully extended,
then open release valve until ram has fully retracted.
7. With pump in normal, horizontal position, locate and
open oil filler screw (located centrally on reservoir
body). This will aid in the release of air trapped
within the reservoir. Retighten the oil filler screw.
8. If using air actuated units, an air source of at least
7.8 CFM @ 90psi is required.
Oil Filler
Screw
Hose
Dust Cover
Figure 1- KTI-63705 and KTI-63711 Nomenclature
Handle
Release Valve
Ram Plunger
Hose
Coupler
Ram Coupler
GENERAL SAFETY INFORMATION
1. Ensure that attachments are fully engaged before
applying load.
2. Ensure that load is centrally applied to attachment
or ram saddle. Do not load off center.
3. Always monitor the force applied to workpiece by
using a load cell and indicator or you may monitor
pressure developed in the ram by using an inline
pressure gauge, then calculate the applied force
using the formula:
F = P x A, where F = lbs force, P = pressure in PSI,
and A = effective ram area in in².
Ram Area of KTI-63705 is: 0.998 in²
Ram Area of KTI-63711 is: 2.431 in²
4. If bowing or bending of ram or any attachment
occurs during use, "STOP", release pressure
immediately and reconsider application. Application
may not be compatible with product, a ram kit with
a higher capacity may be needed.
WARNING
!
• Study, understand, and follow all instructions
provided with and on this device before use.
• Do not exceed rated capacity.
• Use only on hard, level surfaces capable of
sustaining rated capacity loads.
• Do not open oil filler screw unless ram is fully
retracted.
• Always wear safety glasses when using this
equipment.
• Do not use as a vehicle lifting device or as a
vehicle support.
• When extension tubes and/or offset attachments
are used, the rated capacity is always reduced
by 50% for each tube or attachment connected.
• Any attachment that is not loaded centrally, as
through the centerline of the ram, is considered to
be "offset". See parts section for identification of
offset atachments.
• Do not modify this device.
• Failure to heed these markings may result in
personal injury and/or property damage.
3
KTI-63705-M0
Advertisement
