Frigidaire FEB755CESF Installation Instructions Manual

INSTALLATION INSTRUCTIONS

ELECTRIC BUILT-IN
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER
SINGLE AND DOUBLE OVEN MODELS
IMPORTANT NOTE TO INSTALLER:
instructions completely and carefully. Be sure to leave these instruc-
tions with the consumer.
IMPORTANT NOTE TO CONSUMER:
use and care book for future reference. Observe all governing codes
and ordinances. Save these instructions for local inspectors.
Your new wall oven has been designed to fit a wide variety of cutout
sizes to make the job of installing easier.
installation should be to measure your current cutout dimensions and
compare them to the cutout dimension chart for your model shown on
page 2. You may find that little or no cabinet work will be necessary.
1. CARPENTRY
Refer to Figures 1 or 2 for the dimensions applicable to
your model oven, and the space necessary to receive the
oven. The oven support surface may be solid plywood or
similar material, however the surface must be level from
side to side and from front to rear.
2. ELECTRICAL REQUIREMENTS
OBSERVE ALL GOVERNING CODES
AND LOCAL ORDINANCES
IMPORTANT: SAVE THESE INSTRUCTIONS FOR
THE LOCAL ELECTRICAL INSPECTOR'S USE.
A. A three-wire or four-wire single phase 120/240 Volt,
60 Hz AC only electrical supply (or three-wire or four-
wire 120/280 Volt if specified on nameplate) is required
on a separate circuit fused on both sides of the line
(time-delay fuse or circuit breaker is recommended). DO
NOT fuse neutral. The fuse size must not exceed the
circuit rating of the appliance specified on the
nameplate.
Before you begin – read these
Keep these instructions with your
The first step of your
NOTE: Wire sizes and connections must conform with
the fuse size and rating of the appliance in accordance
with the National Electrical Code and local codes and
ordinances.
WARNING: AN EXTENSION CORD SHOULD NOT BE
USED WITH THIS APPLIANCE. SUCH USE MAY RESULT IN
A FIRE, ELECTRICAL SHOCK, OR OTHER PERSONAL
INJURY.
B. The appliance should be connected to the fused
disconnect (or circuit breaker) box through flexible
armored or non-metallic sheathed cable. The flexible
armored cable extending from the appliance should be
connected directly to the junction box. The junction box
should be located as shown in Figure 1 with as much
slack as possible remaining in the cable between the box
and the appliance, so it can be moved, if servicing is ever
necessary.
C. A suitable strain relief must be provided to attach
the flexible armored cable to the junction box.
- 1 -
318064300 (9806) Rev. B
Printed in Canada