Important Safety Warnings - iCoolsport iCool 2020 Compact 3 Series Owner's Manual

Power Supply Voltage
iCools can only be connected to the voltage
marked on the machine. They are manufactured
as either 110v or 220v machines,
are not multi-voltage. Using a different
voltage may cause severe damage.
models can be used on both 50 Hz and 60 Hz
AC supplies.
Built In Safety Systems
Your iCool has many essential safety features to
protect against such things as:
A loss of water flow
Overheating of the system
Electrical shock protection
If any such potentially dangerous situation
should occur, in most cases your iCool will
sound an alarm, shut itself down and a warning
screen will appear to assist you to identify and
correct the problem. Further assistance is
usually available under the "Help" menus.
In the case of overheating, the large main fan
may continue to run for some time even after a
shut down, until the temperature is safely back
to normal.
For the safety of users, any leakage of even a
small amount of electrical current will instantly
cause the Residual Current Device to remove
all electrical power from the entire system. The
maximum leakage allowed is 30 milliamperes
which is considered to be a generally harmless
level.
iCool Compact Series | Owners Manual

Important Safety Warnings

but they
An Approved Earth Connection Is
Essential For Safe Operation
To ensure safe operation the AC power
connection you use must have an earth
connection that complies with your local
All electrical safety regulations.
Never Restart Without Identifying
And Correcting Any Fault
In the unlikely event that your system shuts
itself down for any reason, you must identify and
correct the problem that has caused the safety
system to operate before allowing anyone to
use the iCool.
Electrical Power Connection
The power input socket on the side of your
iCool must be connected to standard AC
power capable of providing at least 13 amps
in countries with a 220 V supply and 26 amps
in countries with a 110 V supply. The iCool
requires much less power than this for normal
operation, however all heat pump compressor
motors need considerably more power for up to
a minute each time they start up and this must
be allowed for.
Page 22