Programming For Devices Featuring Dip Switches; Brand Table - ExcelTek RM-11 Programming Instructions

Programming for devices featuring Dip switches.

❖ With the original remote
1. Open up your original remote to access the Dip switches panel.
2. Set up the dip switches in your ExcelTek™ remote to match your original remote.
3. Press and hold down the program button until the LED light turns blue (about 2 seconds).
4. Choose what remote control button you want to program and press and release it. The LED light will flash. When the LED
light stop flashing, press and release the button again. Continue to press and release up to 18 times until the garage door
opener responds.
5. Once you have a response from your garage door opener, save the programming by clicking the program button on your
ExcelTek™ remote. This turns off the programming mode.
6. Refer to your garage door opener's installation manual for more programming instructions.
Numbers of presses on the
programming button
1
2
3
4
5
6
7
8
★9
10
11
12
13
14
15
16
17
18
*Note: The columns marked with ★ of above compatible list might not applicable, please be kindly noted this before purchasing this item. The rest

Brand Table

Brand Type/Color of Smart/Learn
Linear
Chamberlain
Chamberlain Purple Button '05-Current
Chamberlain
Genie Overhead door
Genie Overhead door
Stanley Security Code '97-Current
Chamberlain Yellow button 2011-current
Wayne Dalton Rolling code 1999-Current
Chamberlain
Chamberlain
Genie
Linear Multi Code
Chamberlain
Stanley / Multi Code
Genie
Linear Moore-O-Matic
Chamberlain
columns are bench tested before delivery.
Mega code '97-Current
Orange Button '97-'05
Green Button '93-'96
Intellicode '95-Current
Intellicode '05-Current
9 Position 1990-1992
9 Position 1983-1989
12 Position 1985
10 Position
8 Position
10 Position
9 Position
8 Position
7 Position
Frequency
318 Mhz
390 Mhz
315 Mhz
390 Mhz
315 Mhz
390 Mhz
310 Mhz
310/315/390 Mhz
372.5 Mhz
390 Mhz
315 Mhz
390 Mhz
300 Mhz
390 Mhz
310 Mhz
390 Mhz
310 Mhz
390 Mhz