Stealth Cam G34MAX Instruction Manual page 12

PIR PHOTO: In this mode the camera will take a photo when trigger is activated.
PHOTO RES: This setting will determine the megapixel
(MP) resolution of each image. A higher MP count will
result in better photos and take more memory space.
OPTIONS: 4 MP | 8 MP | 16 MP | 32 MP
PHOTO BURST: This setting determines how many photos
are taken each time the camera is activated.
OPTIONS: 1 photo – 9 photos
PIR DELAY: This setting is used to determine how long the
camera will wait before reinitializing PIR sensor after
taking a photo.
OPTIONS: 00m 01s – 59m 59s
PIR RANGE: This setting will change the sensitivity of the
PIR sensor on the camera. Distances will vary based on
environment.
OPTIONS:
STANDARD: No change to sensor sensitivity
EXTENDED: Will trigger ~33% further than
STANDARD
NEAR FIELD: Will only trigger on movement very
close to camera
BURST INTERVAL: This setting will determine the time
between each photo taken during a PHOTO BURST.
OPTIONS: 1 sec – 5 sec
REDUCE BLUR: This setting is used to determine if the
camera should use the MATRIX Blur technology to
dramatically reduce the blur effect, resulting in clearer
night time infrared shots.
OPTIONS:
STANDARD: Minimize blurring effect in images
while retaining long-range night image capability
ADVANCED: Enhanced blur reduction providing a
balance between brightness and image sharpness.
PROGRESSIVE: Maximum blur reduction achieved
through faster shutter speed. This setting may
cause a slight reduction in night time range and
increased grain in the image.
IR BRIGHTNESS CONTROL: This setting is used to adjust the
brightness of the IR LEDS.
OPTIONS:
FULL: Default Setting
HALF: Half as bright as FULL. Ideal for close-up shots
SMART IR: This setting is used to toggle Smart IR ON and
OFF. While enabled the camera will take color images
during the dusk and dawn lighting conditions.
While Smart IR is ON, Photo Burst is limited to (1) image per
triggering.
OPTIONS: ON | OFF
Page 12