Sony Reader PRS-T1 User Manual page 12

PRS-T1 | Charging the Reader | Reader™ User Guide
Reader™ User Guide
Getting started
Basic Operations
Adding/Getting Content
Browsing Content Lists
Reading
Organizing
Other Applications
Settings
Other Information
file:///F|/Documents%20and%20Settings/203098/Desktop/4-288-613-11/eng/contents/01/04/01/01.html (1 of 3)7/11/2011 8:58:19 PM
Charging the Reader
The charge/battery status icon at the right side of the status bar shows the battery level.
If it is low, choose one of methods in the following sections to charge the Reader.
While charging, the charge/busy indicator lights up.
1. USB connector
2. Charge/busy indicator
Contents list
Note
If the battery level of the Reader becomes too low, the display may turn off and the power button may stop responding. In this case,
charge the Reader and it will start up automatically after approximately 5 minutes.
Only use the supplied USB cable and, optionally, AC adapter (PRSA-AC10/PRSA-AC1A, not supplied) to charge the Reader. Other
cables/AC adapters may not charge the Reader and could cause damage.
Charge the battery within the temperature range of 5°C to 35°C (41°F to 95°F).
Charging via your computer
It will take approximately 2.5 hours to fully charge the battery.
1. Power on your computer. Do not put your computer in either standby or sleep mode while charging.
2. Connect the Reader to your computer with the USB cable.
Wait until the [USB connected] screen appears on your Reader.
3. There are 2 methods of charging. Tap the desired charging method.
Search
Top page > Getting started > Battery > Charging the Reader
Print