mabe Centauro ICL2040 Series Service Manual page 83

MECHANICAL GUIDE
TO INSTALLATION
7G.- Connect external exhaust using the 4 "diameter
metal conduit and holding with the 2 4" diameter conduit
clamps, taking care that it "does not" become clogged or loose
as shown in the following examples:
8G.- Connect to plumbing fixtures the fill and drain hoses
contained in your product.
9G.- Connect the power cord directly to ground
Do not use adapters or extension
cords, to connect this equipment
you must do it directly, without
overloading the contact.
11 | Manual de Servicio
10G.- For your safety and correct operation of the
equipment, use the washing
recommendations detailed in the user and installation manual
contained in the new product.
ELECTRIC LAUNDRY CENTER
Electrical requirements:
50Hz or 220V / 60Hz must be connected to an
individual branch circuit, protected by suitable time-delay
fuses or circuit breakers. A 120 / 240v or 120 / 208v, 60
Hz, 30 amp single phase four or three wire circuit is
required. If the electrical supply does not meet the above
requirements, call a qualified electrician.
Steps to connect your laundry center
ELECTRIC:
1E.- Verify that your installation corresponds to what
is established on your product label (voltage).
Perform the following steps from the Gas Laundry
Centers Section:
2G, 3G, 4G, 5G, 7G, 8G, 9G, 10G
6E Connect to power supply: connect the power cord. It
is essential to have an electrician make the proper connection
to your dryer for added safety.
For your convenience, a plugless power cord is included
so that you can choose the type of plug according to the outlet
you have in your home. (See the installation manual
contained in your product for more details and safety, do not
skip any recommended steps).
center following the
If your product is 220V /
Ingenieria de Servicio