Advertisement
How often have you needed a large guiding surface on
a router table? Your Sears Craftsman Router Table with
Unitized Fence comes with:
a.
A unique 4" high unitized fence designed to assist
for end grain routing for making tenons, sliding
dovetails and tongue and groove joints along with
most edge and face cutting operations.
b.
A specially designed push blo€k with quick clamp
for back up and clamping boards up to 4" width for
end grain routing.
c.
An accurate and quick adjusting jointing fence
adjustable to proper jointing depth of cut.
d.
Reversing feature of unitized fence designed to
enable routing operations
veining; crown molding etc. up to 21/2" away from
the edge towards the middle of the board.
UNPACKING AND
CHECKING CONTENTS
Refer to Parts List on Page 16
WARNING
YOU MUST READ AND UNDERSTAND
ASSEMBLE AND OPERATE YOUR ROUTERI ROUTER TABLE.
ASSEMBLY OF TABLE
1. Turn the table upside down.
2. Place one of the table legs in one corner of the table
as shown in Fig. #1.
#10-32 x 5/8"
#10 Lock Washer
Pan Head Screw
3. Insert the 10-32 x 5/8 machine screws through the
table top and leg.
4. Lightly tighten the nuts and lock washers on each
screw. The lock washers should be against the
inside of the leg.
5. Repeat for the remaining three legs.
INTRODUCTION
like grooving; fluting;
ALL THE INSTRUCTIONS COMPLETELY BEFORE ATTEMPTING TO
Leg
#10-32 Hex Nut
Fig. #1
e.
Two guards for operation on either side of the uni-
tized fence.
f.
Dust collecting attachment for most shop vac. hook
ups.
If order to facilitate handling and minimize any damage
that might occur during shipment, your new router table
is packaged unassembled. We know you are anxious
to see what your new tool will do, but a few minutes
spent now carefully reading the following instructions,
will result in less frustration and more enjoyable opera-
tion later.
Start by checking and accounting for all the loose parts.
If any parts are missing, contact your local Sears retail
or catalog outlet for replacement.
6. Turn the table right side up and tighten all 16
screws and nuts with a screwdriver and wrench or
pliers.
MOUNTING ROUTER TO TABLE
ALWAYS UNPLUG ROUTER BEFORE MOUNTING
(The table will accept Sears routers with bases up to
(blerO
6" in diameter).
p
ATTACHING SEARS ROUTERS WITH THREE HOLE
BASE PLATES.
1. Remove the router base plate (back plate) from the
router.
2. While holding the router upside down, position it
to the underside within the center ring of the table
top as shown in Fig. #2.
4
Center Ring
Fig. #2
Advertisement
