Advertisement
,;,;,--
NOTE: When cutting tenons, always clamp work-
piece with end to be cut resting on edge
of table top hole. This will minimize steps
in finished tenon surface (Fig. #29) due to
variations in the table top flatness.
Fig. #29
WARNING:
ALWAYS
ALL 4 SIDES OF TENON IN ONE
PASS ACROSS
THE
SIDES
STEPS
TIONS
ARE NOTICED
ISHED TENON SURFACE, CLEAN
THEM WITH WOOD CHISEL, SAND
PAPER OR FILE, ETC. DO NOT TRY
TO CLEAN THEM BY RE-SETTING
WORKPIECE ON ROUTER TABLE
AND FENCE. WORKPIECE
INTERFERE
FIG. #27 ABOVE) WHICH IN TURN
WILL PREVENT IT FROM SLIDING
ACROSS THE BIT.
OPERATION -
BACKSIDE OF UNITIZED FENCE
USE BACKSIDE OF FENCE ONLY FOR ROUTING
OPERATIONS AWAY FROM EDGE ON THE UNDER-
OF WORKPIECE SUCH AS GROOVING; FLUT-
VEINING; CROWN MOLDING, ETC.
JaIMVS
UNPLUG THE ROUTER BEFORE MAKING
MY
lETTING,
ADJUSTMENTS,
BITS.
WHEN ROUTING
ALWAYS
ROTATION OF THE CUTTER. FEED WORKPIECE IN
THE DIRECTION OF ARROW AS SHOWN ON LABEL
ON THE SIDE OF FENCE BEING USED (when facing
the table front).
Steps in Finished
Tenon Surface
CUT FULL DEPTH ON
THE BIT. ONCE
ARE
CUT AND
IF
OR OTHER
IMPERFEC-
ON FIN-
MAY
WITH GUARD
(SEE
ROUTING USING
OR CHANGING
FEED AGAINST
THE
DO NOT CONNECT SHOP VAC. WHEN USING BACK-
SIDE
OF FENCE.
OPERATION,
For maximum accuracy, one edge of your workpiece
(edge sliding against the fence) must be true and
straight. Set up your fence as follows:
1. Remove both large knobs and 1/4-20 x 1 3/4" Ig.
hex head bolts, turn the unitized fence around and
attach it back to table with backside of fence fac-
ing the table front. See Fig. #30. (MAKE SURE
ROUTER IS UNPLUGGED
AND ATIACHING
Table Front
2. Raise guard and let it lean against the fence.
3. Position the fence behind the router bit for the
desired cutting depth (the distance of the cut from
the edge of the workpiece, as shown in Fig. #31).
13
THE
HOSE
WILL
HINDER
WHEN REMOVING
FENCE TO TABLE).
Back Side of Unitized Fence
Fig. #30
."..-.
Advertisement
