Table of Contents
Advertisement
Installing the Wiper
Installing the Wiper
1. Align the clip nut so that the flat leg of the clip nut
faces away from the mower deck
Note: Position the 4 clip nuts over the wiper flange
of the striping bracket. Align the clip nuts holes with
the bracket holes.
1. Mower deck installation
2. Skid
3. Clip nut
4. Washer-head screw
(self-threading)
5. Washer
2. Position the wiper on the wiper flange of the striping
bracket
(Figure
2).
Note: Align the holes in the wiper with the clip nuts.
3. Secure the wiper to the bracket using the 4 hex-head
screws (5/16 x 3/4 inch) and 4 washers as shown in
Figure
2.
(Figure
2).
Figure 2
6. Hex-head screw
7. Wiper
8. Striping bracket
9. Mounting bracket
Installing the Mower
Note: Squealing when the belt is rotating, blades slipping
when cutting grass, frayed belt edges, burn marks, and cracks
are signs of a worn mower belt. Replace the mower belt if any
of these conditions are evident.
1. Install the mower belt
the Replacing the Mower Belt section in the Operator's
Manual.
2. Install the mower deck to the machine. Refer to the
Installing the Mower section in the Operator's Manual or
the appropriate section of the Service Manual
3
(Figure 3
), if removed. Refer to
Figure 3
Advertisement
Table of Contents
