www.intertec.info Table of contents 1 General .................................. 3 2 Use ................................... 3 3 Explanation of symbols for warnings and signal words .................. 3 4 Technical Data ................................ 3 5 Installation................................ 4 6 Connection................................ 4 7 Commissioning............................... 5 8 Maintenance................................ 5 9 Troubleshooting ..............................
NOTE The type TS is installed in the connection line of the It is essential to pay attention to this safety advice as you radiator at the factory (standard version).
Operating Instructions Thermostat TS/TSE It must be switched electrically in series with the radiator Dimensions H x W x D 22 x 30 x 22 mm in an Ex e junction box. Mean Time Before Failure 50.000 h Storage temperature - 60 to + 80 °C...
In case of a fault, first check the function of the downstream operating equipment. Heating The fault is caused by the temperature switch: br=brown bl=blue ye/gn=yellow/green bk=black gr=grey Fault Cause Effect/Measure Illustration 2: CP ..THERM with TS Device runs Temperature Check continuously switch (power installation, Commissioning...
Operating Instructions Thermostat TS/TSE Safety information NOTICE Environmental damage may be caused if CAUTION disposed of incorrectly! Risk of injury at the rib ends Electrical scrap and electronics components are subject to hazardous waste treatment and must only be...
Operating Instructions Thermostat TS/TSE Further information and service If the information contained in this instruction manual should not be sufficient in any way, then INTERTEC would be glad to be at your disposal to provide further information and service.
Need help?
Do you have a question about the TS and is the answer not in the manual?
Questions and answers