Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ADENDORFF MAC AFRIC SDRILC-007
Summary of Contents for ADENDORFF MAC AFRIC SDRILC-007
-
Page 2: General Power Tool Safety Warnings
9. If operating a power in a damp location is unavoidable, use a residual current device (RCD) GENERAL POWER TOOL SAFETY WARNINGS protected supply. Use of an RCD reduces the risk of electric shock. (For All Power Tools) NOTE: The term “residual current device (RCD)” may be replaced by the term “ground fault Failure to follow all WARNING! Read and understand all instructions. -
Page 3: Specifications
preventive safety measures reduce the risk of starting the power tool accidentally. APPLICATIONS 20. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous ... - Page 4 4. Hold tool by insulated gripping surfaces when performing an operation on wall and floor 3. It’s normal that the battery and charger will become warmer while in charging. where the cutting tool may contact hidden wiring. Contact with a “live” wire will also make 4.
-
Page 5: General Descriptions
Do not remove the battery forcibly. terminals together may cause sparks, burns, or a fire. 20. Do not dispose of damaged or worn out battery into household waste, fire or water. Please set the reversing switch lever to the 21. -
Page 6: Battery Charging
2. Charging Operation Four red LED lights are set to indicate the battery power which can be referred to the following table. Status of Red LED Lights Approx. Battery Power Left 1. Plug the battery charger into the proper AC power source. The charging indicator light will 4 lights lit 75%～100% flicker in green color and the charger operates in standby mode. - Page 7 Installing or Removing Tools Never operating in a low rotation speed for long time, otherwise it will cause overheat inside the The tool here includes driver bit, drill bit, etc, which differs from the concept of power tools or machine.
-
Page 8: Maintenance And Inspection
Work Light MAINTENANCE AND INSPECTION The white LED work light will be lit after pulling the switch trigger for illumination of the work area under Inspecting unfavorable lighting conditions. (Fig. 10) When the tool is distributed or withdrew, the custodial staff must give it a daily inspection; before use, users must give it a daily inspection;... - Page 9 EXPLANATION OF GENERAL VIEW Circlip for Shaft Driving Gear Washer Ball Bearing Locking Cover Armature Assembly Compression Spring Ball Bearing Pan Head Tapping Screw (with Pan Head Tapping Screw Spring Washer) Front Cover Hall Plate Spindle Sleeve Stator Assembly Baffle Ring Reversing Switch Lever Washer Torque Setting Board...
Need help?
Do you have a question about the MAC AFRIC SDRILC-007 and is the answer not in the manual?
Questions and answers