ADENDORFF MAC AFRIC SWRENC-001 Original Operating Instructions
  1. Manuals
  2. Brands
  3. ADENDORFF Manuals
  4. Power Tool
  5. MAC AFRIC SWRENC-001
  6. Original operating instructions

ADENDORFF MAC AFRIC SWRENC-001 Original Operating Instructions

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MAC AFRIC SWRENC-001 and is the answer not in the manual?

Questions and answers

Related Manuals for ADENDORFF MAC AFRIC SWRENC-001

Summary of Contents for ADENDORFF MAC AFRIC SWRENC-001

  • Page 2: General Power Tool Safety Warnings

    Use of a cord suitable for outdoor use reduces the risk of electric shock. GENERAL POWER TOOL SAFETY WARNINGS 9. If operating a power in a damp location is unavoidable, use a residual current device (RCD) (For All Power Tools) Use of an RCD reduces the risk of electric shock.

  • Page 3: Specifications

    Service controlled with the switch is dangerous and must be repaired. 19. Disconnect the plug from the power source and/or the battery pack from the power tool 28. Have your power tool serviced by a qualified repair person using only identical replacement Such before making any adjustments, changing accessories, or storing power tools.
  • Page 4 brand, may result in a risk of battery burst causing personal injury and property damage. SAVE THESE INSTRUCTIONS. 4. Be sure that the battery is installed correctly and tightly before operating the tool. 5. Always wear protective devices to avoid personal injury. WARNING! MISUSE or failure to follow the safety rules stated in this instruction manual may 6.

  • Page 5: General Descriptions

    with the adjacent components. Clean such parts or replace them, if required. If electrolyte 24. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when contacts with your skin, wash the contacted area with soap firstly and then wash with disconnecting charger.

  • Page 6: Instructions For Operation

    To remove the socket, uncover the rubber INSTRUCTIONS FOR OPERATION ring and pill out the pin. Then pull the socket Tightening Bolt as the direction of arrow. CAUTION: (Fig. 4) Point the bolt to threaded hole as vertically as possible. Switch Action Place the socket in the bolt head and apply CAUTION:...

  • Page 7: Installing/Removing The Battery

    Step H When not operating the tool, always set the reversing switch lever to the center  position. Press the trigger and run the tool at high speed. The maximum torque can reach 300 N·m in  Never force to pull the switch trigger while the reversing switch lever is set at the average.

  • Page 8: Battery Charging

    Status of RED LED Lights Approx. Battery Power Left 2. Insert the battery pack fully into the battery charger and the charger starts charging. 4 lights lit ≥3/4 The battery charger can detect some sort of failure caused by the battery and indicates by the 3 lights lit ≥1/2 statuses of the red and green indicator lights.

  • Page 9: Maintenance

    USE CASE MAINTENANCE CAUTION: CAUTION: Accessories mentioned in the following figure and user manual are not offered with tool.   Always be sure that the tool is switched off and the battery is removed before attempting to  For those threads that have special demand for torque, use torque wrench to check the perform inspection or maintenance.
  • Page 10 EXPLANATION OF GENERAL VIEW Pan Head Tapping Screw Ball Bearing Spring Washer Stator Assembly Mechanical Output Assembly Pan Head Tapping Screw Front Cover for Gear Housing Hall Plate Spindle Sleeve Stator Circlip LED Light Shade Washer Torque Setting Baffle Ring Reversing Switch Lever Seal Left-half Motor Housing...

Table of Contents