COMPONENT ACCESS (Cont.)
Components inside the Cabinet (Continued)
Heater
8. Remove two (2) fixing screws of the heater.
9. Disconnect the connector and remove the heater.
PTC Heater Fan
1. Complete the steps
1-7
removal instructions.
2. Remove the four (4) screws securing the fan.
A. Fan cover and fan
B. Lower compartment sensor
3. Remove the fan cover and PTC heater fan.
n
4-4
Wine Center
from Air-Duct Panels A, B, and C
A
B
NOTES:
Ƀ Engineering Model Numbers with R134a gas - Follow normal
sealed system purging, capturing, brazing and charging
procedures for models: WUW35X15DS01, WUW35X24DS01,
WUW55X15DS01, WUW55X24DS01, WUW55X15HS00, and
WUW55X24HS00.
Ƀ Engineering Model Numbers with R600a gas (new
compressor and PCB) - Follow R600a sealed system purging,
capturing, lokring, and charging procedures outlined in
Service Manual
W11105483
WUW35X24DS02, WUW55X15HS01, and WUW55X24HS01.
Evaporator
1. Complete the steps
1-7
removal instructions.
2. Remove the evaporator.
Evaporator Fans under the Air-Duct Panel B
1. Complete the steps
1-2
instructions.
A. Air-Duct Panel B
2. Disconnect the fan connectors.
3. Pull the evaporator fan upwards and remove.
A. Lower compartment fan
B. Upper compartment (evaporator) fan
for models: WUW35X15DS02,
from Air-Duct Panels A, B, and C
from Air-Duct Panel B removal
A
A
B