Advertisement
TURN GATE OPENER OFF
4.
Connect the BLACK to the terminal labeled
COMMON, and the BLUE wire to terminal in
STEP 3 to open gate. See wiring diagrams to
the right for guidance on wiring the sensor to your
gate opener's control board.
5.
Connect the POWER INPUT wires from the
Exit Wand Sensor (if not already connected to a
terminal on the board).
•
Connect the YELLOW and BRAIDED
GROUND wires to the (–) NEGATIVE side of
power source (i.e. battery).
Connect the RED wire to the (+) POSITIVE
•
side of power source (i.e. battery).
Double Spade Connectors
included with SENSOR
Battery Cable
BLACK (-)
YELLOW wire from
SENSOR CABLE
BRAIDED GROUND
from SENSOR Cable
RED wire from SENSOR Cable
BLACK BATTERY CONNECTION WIRE
with Spade Connector included with SENSOR
I M PO RTAN T
WHEN THE WAND IS FIRST POWERED
UP IT MUST BE UNDISTURBED FOR 60
SECONDS TO PERFORM THE SELF TEST
AND CALIBRATIONS. BEFORE POWERING
THE WAND MAKE SURE THERE ARE NO
MOVING METAL OBJECTS OR MOVING
VEHICLES WITHIN THE RANGE OF
THE WAND
6.
Turn opener ON and TEST.
Battery Cable
RED (+)
RED BATTERY CONNECTION WIRE
with Spade Connector included
with SENSOR
WIRING DIAGRAM EXAMPLES
NOTE: Power Input Connections Not Shown.
(See gate instruction manual for complete instructions)
RED
YELLOW + BRAIDED
Connect the RED
Connect the BLACK
wire from the SENSOR
CABLE to the AUX V+
wire from the SENSOR
terminal on the opener
CABLE to one of the
control board.
COMMON terminals on
the opener control board.
Connect the YELLOW
BLACK
wire and BRAIDED GROUND
wire from the SENSOR
BLUE
CABLE to the AUX V- terminal
on the opener control board.
LINK
18VAC/
H
L
AUX
SOLAR
OUT
INPUT
Connect the
BLUE wire from
the SENSOR
CABLE to the
EXIT terminal on
Connect the RED
BLACK
the opener
wire from the
control board.
SENSOR CABLE
to the H AUX OUT
BLUE
terminal on the
opener board.
Connect the BLUE wire from
the SENSOR CABLE to the
EXIT terminal on the opener
control board.
BLUE
Connect the
BLACK wire,
YELLOW wire and BRAIDED
BLACK
GROUND wire
from the
SENSOR CABLE to one of the
COMMON terminals on the
opener control board.
YELLOW
See the diagram to the left for battery connection instructions
for the RED, YELLOW AND BRAIDED GROUND wires.
CONTROL INPUTS
Connect the BLACK wire
from the SENSOR CABLE
to one of the COMMON
terminals on the opener
control board.
Connect the BLUE wire from
the SENSOR CABLE to the
EXIT terminal on the opener
BLACK
control board.
BLUE
YELLOW
Connect the BLACK wire, YELLOW wire and BRAIDED GROUND
wire to one of the COMMON terminals on the opener control board.
Connect the BLUE
wire from the SENSOR
CABLE to the EXIT
terminal on the opener
control board.
Connect the BLACK
RECR
wire, YELLOW wire and
BRAIDED GROUND
wire from the SENSOR
CABLE to one of the
COMMON terminals on
the opener control board.
BRAIDED
YELLOW
FIRST OPR.
SECOND OPR.
Connect the RED wire from the
SENSOR CABLE to the LOCK+
terminal on the opener control
board.
RED
BRAIDED
RECEIVER
ALM
RCVR.
Connect the BLUE wire from
the SENSOR CABLE to the
EXIT terminal on the opener
control board.
BLUE
BLACK
Connect the
RED wire from
the SENSOR
CABLE to the
BRAIDED
LOCK+ terminal
on the opener
control board.
3
Advertisement
