Table of Contents
Advertisement
SAFETY EQUIPMENT
Header Lift Cylinder Stop
A header lift cylinder stop is located on the left-hand
header lift hydraulic cylinder.
FIG. 38: Header lift cylinder stop (1) in the disengaged
position.
FIG. 39: Header lift cylinder stop (1) in the engaged
position.
Properly engage the header lift cylinder stop as shown
before going under the header or feeder house for any
reason.
To engage the header lift cylinder stop:
1. Raise the feeder house until the cylinder rod is fully
extended.
2. Release the hook and lower the header lift cylinder
stop onto the cylinder rod.
3. Lower feeder house until the header lift cylinder stop
contacts the end of the cylinder.
Wheel Chocks
FIG. 40: Wheel chocks (1) are included with the combine
and are stored on the left-hand side of the combine.
Use wheel chocks in front of and behind the left-hand
drive tire any time the combine is parked. Return the
wheel chocks to the mounting brackets after use.
700735891 F Rev.
FIG. 38
FIG. 39
FIG. 40
SAFETY
1
N516689
1
N516587
1
D-12494
A-19
Advertisement
Table of Contents
