Qlight QWCD35 Manual page 3

Parts Definition and Installation
QWCD35
Cable gland
Body(Material:PC+ABS)
Terminal block
PCB
Horn(Material:PC)
Resonator(Material:PC)
■ Installation
• First, make taps or holes that match the product
mounting bolts locations on the mounting surface ① .
• The mounting hole of this product is 9mm in
diameter(long hole).
• If the tap is machined, fasten the bolt through the
mounting hole of the product.
• When machining a hole, insert the bolt through the
product, insert it into the hole, and tighten the nut
from the opposite side of the mounting surface.
• Install a flat washer and a spring washer to the bolt
if the product can experience severe vibration and
shock.
3
QWCD35SD
SD card slot
Cable gland
Body(Material:PC+ABS)
SD card
- SD cards are sold separately
■ Tap Machining
■ Hole Machining
Terminal block
PCB
Horn(Material:PC)
Resonator(Material:PC)