Toyotomi TAD-T38J Service Manual page 9

8. DISASSEMBLING
WARNING
• Make sure to disconnect the power source before disassembling the unit.
• Carefully disassemble the unit. Do not touch evaporator and condenser directly or you may cut or injure your
hands.
CAUTION
• Do not touch the compressor, the discharge pipes, or any parts that may be subjected to high temperature,
before the temperature becomes low .
1. Remove two (2) screws \ from the front cover N
and remove two screws ] from the top of the rear
panel I to remove the front cover. Lift up the front
cover and disconnect the connecters of the circuit
board.
2. Remove six (6) screws \ from the back of the front
panel G to remove the front panel.
In this condition, you can check all of the parts.
3. Remove three (3) screws ] from the bottom of the
rear panel I and two (2) screws ] from the central
part of the rear panel (inside). Remove two (2)
screws \ from the top of the rear panel and three
(3) screws \ from the central part of the rear panel
to remove the rear panel.
1-2
I
]
\
\
3
I
\
\
]
8
\
N
G
N
G
]