Spraying Instructions - Campbell Hausfeld IN425101AV Operating And Assembly Instructions Manual

Campbell hausfeld airless paint sprayers operating and assembly instructions
Table of Contents

Advertisement

Operating Instructions and Assembly Instructions
Airless Paint Sprayers
Preparation (Continued)
10. After completing the flush/testing
process, purge the pump of fluid.
11. Repeat the preceding steps using
paint instead of cleaning solvent.
NOTE: Strain and thin paint before
using. All paint may have particles that
will clog filter and spray tips. Remove
any skin which may have developed on

Spraying Instructions

Professional looking results can be
obtained by following the spray tips
below.
1. Keep the gun perpendicular to the
surface.
Always hold the gun perpendicular
to the surface with the tip
approximately 12 inches from the
surface. If held at an angle (up
and down or side to side), paint
will build up unevenly, leave the
work splotchy, and cause excessive
overspray (See Figure to the right).
2. Move with a smooth arm stroke.
Move the gun at a steady, even
pace while keeping the gun
perpendicular to the surface (See
Figures to the right). Do not fan
the gun. Fanning the gun will cause
excessive overspray and uneven
coverage (See Figure to the right).
3. Start moving the gun before
triggering.
To get a smooth overlap and prevent
initial paint buildup, start your
stroke movement before pulling the
trigger. Release the trigger before
stopping at the end of the stroke
(See Figure to the right).
NOTE: To assure uniform paint
coverage, overlap each stroke by 20%
- 30% and use two coats with a cross
pattern (one coat horizontal, second
coat vertical).
www.chpower.com
the paint due to air exposure. Follow
paint manufacturers' recommendations
on thinning paint.
12. When pure paint appears from
spray tip rotate tip to the SPRAY
position. The system is now ready
for use.
Holding Spray Gun
Heavy
Thin Coat
Coat
Over-
spray
Result of Flexing Wrist While Spraying
Approx.
10-12"
Pull
Trigger
Start
Stroke
Proper Way to Trigger Spray Gun
8
12"
1
2
Thin Coat
Over-
spray
Release
Trigger
End
Stroke
CLEAN Position
SPRAY Position
Water
Prevent clogged tip

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ps270dPs290dPs271d

Table of Contents

Save Article as PDF