Campbell Hausfeld PS240C Operating And Assembly Instructions Manual page 5

Operating Instructions and Assembly Instructions
Airless Paint Sprayers
Before servicing or resting:
1. Turn the Prime/Spray Control to the
PRIME position.
2. Turn the pressure control to LOW
PRESSURE/HYDRAULIC BLEEDING
position.
3. Turn power switch to OFF position.
4. With gun pointed in a safe direction,
pull the gun trigger, with the
trigger lock disengaged.
5. Engage trigger lock.
● Simply turning off the pump motor
will not relieve pressure from
system. The above procedure MUST
be followed.
FIrE Or ExPlOSION hAzArD:
● Do not use solvents with flash points
less than 70°F (21°C) to clean this
equipment (examples of acceptable
cleaning solvents are water, mineral
spirits, lacquer thinner, Xylene and
high flash napha. A partial example
list of unacceptable cleaning
solvents are low flash napha, mek,
acetone, alcohol and toluene).
● Use only conductive or grounded
high-pressure airless paint sprayer
hoses specified by the manufacturer.
● Verify that all containers and
collection systems are grounded to
prevent static discharge.
● Do not spray pump assembly.
● Have fire extinguisher equipment
present and working.
Do not spray flammable
materials in vicinity of
open flame or near ignition
sources. Motors, electrical equipment
and controls can cause electrical arcs
that will ignite a flammable gas or
vapor. Never store flammable liquids or
gases in the vicinity of the unit.
toxic chemicals, fertilizers or pesticides.
using these materials could result in
death or serious injury.
● Do not use fuels to clean this
equipment.
● Keep spray area well ventilated.
Keep a good supply of fresh air
moving through the spray area.
● Remove all ignition sources (i.e.
Static electricity, pilot lights,
cigarettes and electrical arcing).
● Airless spraying can cause static
electricity. Always ground the pump
and spraying surface. Always use a
3-wire grounded extension cord and
power receptacle.
● Do not use paints or solvents
containing halogenated
hydrocarbons such as methyl
bromine, carbon tetrachloride, and
ethyl iodine.
Bursting hoses may cause injury.
Examine hoses regularly and replace if
damaged.
● Check hoses for weak or worn
condition before each use, making
certain that all connections are
secure.
● Keep area clean and free of paint or
solvent containers, rags, and other
flammable materials.
TO rEDUCE ThE rISk OF INjUry:
● Do not spray acids,
corrosive materials, toxic
chemicals, fertilizers, or
pesticides. Using these
materials could result in
death or serious injury.
● Do not kink or over-bend the hose.
● Do not expose the hose to
temperatures or to pressures in
Do not spray acids,
corrosive materials,
● Do not use the hose as a strength
● Always wear appropriate gloves, eye
● Always work in a clean environment.
● Do not operate or spray near
● Do not over reach or stand on an
● Stay alert and watch what you are
● Do not operate the equipment when
Keep hose away
from sharp objects.
5
excess of those specified by the
manufacturer.
member to pull or lift the
equipment.
protection, and a respirator or mask
when painting.
Do not aim the spray gun at any
dust or debris.
children. Keep children, pets, and
visitors away from equipment and
work area at all times.
unstable support. Keep effective
footing and balance at all times.
doing.
fatigued or under the influence of
drugs or alcohol.
FAIlUrE TO FOllOw
ThESE INSTrUCTIONS
CAN rESUlT IN
SErIOUS INjUry
INClUDING DEATh.
www.chpower.com