NEC 55" InfinityBoard 2.1 User Manual page 4

All-in-one collaboration solution
Hide thumbs Also See for 55" InfinityBoard 2.1:
Table of Contents

Advertisement

Copyright Information
indows is a registered trademark of Microsoft Corporation.
NEC is a registered trademark of NEC Corporation.
MultiSync is a trademark or registered trademark of NEC Display Solutions, Ltd. in Japan and other countries.
ErgoDesign is a registered trademark of NEC Display Solutions, Ltd. in Austria, Benelux, Denmark, France,
Nermany, Italy, Norway, Spain, Sweden, U.K.
DisplayPort and DisplayPort Compliance Logo are trademarks owned by Video Electronics Standards Association in
the United States and other countries.
The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are
trademarks or registered trademarks of HDMI Licensing Administrator, Inc. in the United States
and other countries.
Trademark PJLink is a trademark applied for trademark rights in Japan, the United States of
America and other countries and areas.
microSD and microSD SDHC logos are trademarks of SD 3C, LLC.
CRESTRON and CRESTRON ROOMVIE are trademarks or registered trademarks of Crestron
Electronics, Inc. in the United States and other countries.
Raspberry Pi is a trademark of the Raspberry Pi Foundation.
Adobe and the Adobe logo are either registered trademarks or trademarks of Adobe Systems Incorporated in the
United States and/or other countries.
All other brands and product names are trademarks or registered trademarks of their respective owners.
OOTE:

(1) The contents of this user's manual may not be reprinted in part or whole without permission.
(2) The contents of this user's manual are subject to change without notice.
(3) Nreat care has been taken in the preparation of this user's manual; however, should you notice any questionable
points, errors or omissions, please contact us.
(4) The image shown in this user's manual is indicative only. If there is inconsistency between the image and the
actual product, the actual product shall govern.
(5) Notwithstanding articles (3) and (4), NEC will not be responsible for any claims on loss of profit or other matters
deemed to result from using this device.
GPL/LGPL Software Licenses
The product includes software licensed under NNU Neneral Public License (NPL), NNU Lesser Neneral Public License (LNPL),
and others. For more information on each software, see "readme.pdf" inside the "about NPL&LNPL" folder on the supplied
CD-ROM.
Registration information
Cable Information
CAUTION:

Use the provided specified cables with this product so as not to interfere with radio and television reception.
For mini D-Sub 15-pin, please use a shielded signal cable with ferrite core.
For HDMI, DisplayPort, USB and D-Sub 9-pin, please use a shielded signal cable.
Use of other cables and adapters may cause interference with radio and television reception.
FCC Information

ARNINN:
The Federal Communications Commission does not allow any modifications or changes to the unit EXCEPT
those specified by NEC Display Solutions of America, Inc. in this manual. Failure to comply with this government
regulation could void your right to operate this equipment.
1. The power supply cord you use must have been approved by and comply with the safety standards of U.S.A., and meet
the following condition.
2. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Power supply
Non shield type,
cord
3-conductor
Plug shape
U.S.A.
English−4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ib554q-2.1Infinityboard 2.1

Table of Contents