Installing The Cutting Head - Carnival King ROYALTY Series User Manual

Blade Maintenance & Replacement Instructions
Remove the Cutting Head (Caution: Sharp Blades)
Note: you may have to remove the motor cover to access cutting head.
1. Turn off the POWER switch.
2. Rotate the cutting head until the setscrew is accessible through the discharge opening located inside the top panel of the
tub frame.
3. Use a 1/8" hex wrench to loosen the set-screws.
4. Carefully slide the cutting head off the motor shaft and remove the cutting head out of the top side, inlet, of the ice horn.
Cutting Head Blade Replacement
5. Remove the two screws per blade.
6. Lift the old blades out.
7. Position the new blades on the head with the cutting edge extending between 1/32" to 1/16" out from the cutting head
surface. This setting will determine the size of the ice. The more blade that is exposed beyond the head will create a
coarser ice chip.
8. Use the blade screws to secure the blades to the head.

Installing the Cutting Head

9. Slide the cutting head down into the ice horn with the coupler end first.
10. As the cutting head is slipped onto the motor shaft, align the setscrews to the flat location of the motor shaft.
11. Tighten the setscrews with a 1/8" hex wrench.
12. Machine is now ready for use.
13. Reinstall motor cover.
www.CarnivalKingSupplies.com
.
| | | | | info@carnivalking.com
Manual
7