Table of Contents
Advertisement
Cleaning and Maintenance
To maintain the appearance and increase the service life, clean your unit daily.
NOTE: Do not clean the unit with steel wool.
1. Operate the motor for several minutes to remove any water collection on the cutter head.
2. Turn off the POWER switch and allow the unit to cool completely before cleaning.
3. Remove all ice from the ice horn and storage compartment.
4. Unplug the power cord from the electrical outlet.
5. Using a clean cloth, wipe down the following items:
a. The inner surface of the ice horn (Caution: Sharp Blades)
b. The outside surface of the ice horn casting.
c. The ice pusher.
d. All interior and exterior surfaces.
6. To clean the water collection tray:
a. Tilt tray to drain the water trapped in the drain cavity.
b. Slip the drain hose off the nipple fitting.
c. Lift the tray out of the cabinet
d. Clean tray and area below tray with clean cloth.
7. The base and exterior of the unit can be cleaned with a damp cloth, light soap and water.
a. Recommended: Use Spiffy Shine (999SPIFSHINE) for exterior base and frame.
8. Do not immerse in or use excessive water when cleaning this unit.
9. Only use food grade cleaners.
Warning
Do not spray water or cleaning products. Liquid could contact the electrical components and cause a short circuit or an
electrical shock. Do not use unit if power cord is damaged or has been modified.
www.CarnivalKingSupplies.com
.
| | | | | info@carnivalking.com
Manual
5
Advertisement
Table of Contents
