Step 2 Adjust Leveling Legs; Step 3 Remove Toekick; Step 4 Install 90° Elbow - Frigidaire FFBD1821M Installation Instructions Manual

STEP 2 ADJUST LEVELING LEGS

• Move the dishwasher close to the installation location
and lay it on its back.
Adjust to
Installation
Height
Figure H
• Measure installation height and dishwasher height.
Extend leveling legs out from the dishwasher base,
1/4" less than installation height.

STEP 3 REMOVE TOEKICK

• Remove the 4 toekick screws. Lift off the 2 piece
toekick.
Remove
4 Toekick
Screws
Figure J
Installation Instructions
STEP 4 INSTALL 90° ELBOW
• Wrap 90° elbow with thread seal tape.
• Install a 90° elbow onto the water valve.
90°
Elbow
Figure L
• Do not over tighten 90° elbow, water valve bracket
could bend or water valve fitting could break.
• Position the end of the elbow to face the rear of the
dishwasher.
6
Fill
Hose
Water
Valve
Bracket
Thread
Seal Tape