Bosch rexroth 1 Series Instruction Manual page 47

Changing connector
position
2
1
Tightening torque for
Hirschmann connectors
Exact details on the connector, type of protection and matching mating connector
can also be found in data sheet 93100. The mating connector is not included in the
scope of delivery.
1. Switch off the power supply to the relevant system component.
Electrically connect the axial piston unit (12 or 24 V). Before establishing
2.
the connection, check whether the connector protective covers have been
removed and the connector and all seals are intact.
For more far-reaching information that is not contained in data sheet 93100
please refer to the following data sheets:
– Data sheet 92703 for size 60
– Data sheet 92500 for sizes 95 to 260
– Data sheet 92076 for size 520
If necessary, you can change the position of the connector by turning the solenoid
body. This is independent of the connector version.
CAUTION! Hot surfaces on the solenoid!
Risk of burning!
▶ Allow the solenoid to cool down sufficiently before touching it.
▶ Protect yourself with heat-resistant protective clothing, e.g. gloves.
To do this, proceed as follows:
1. Loosen the mounting nut (1) of the solenoid. To do this, turn the mounting
nut (1) one turn counter-clockwise.
2. Turn the solenoid body (2) to the desired position.
3. Re-tighten the mounting nut. Tightening torque of the mounting nut: 5+1 Nm.
On axial piston units with a Hirschmann connector according
to DIN EN 175 301-803-A/ISO 4400, the following tightening torques apply when
mounting plug-in connectors:
• Mounting bolt M3 (1): 0.5 Nm
• Union nut M16 × 1.5 (2): 1.5–2.5 Nm
1
2
Fig. 22: Hirschmann connector
RE 93100-01-B/2019-09-10, A20V(L)O Series 1, Bosch Rexroth AG
Installation 47/68