Page 1
GS1-100 Air Filtration System Operations Manual READ AND SAVE THESE INSTRUCTIONS WARNING: Disconnect from power supply before performing maintenance procedures such as cabinet cleaning, changing filters or servicing of electric motor or other electric components WARNING: To reduce the risk of fire or electric shock, do not use this fan with any solid- state speed control device.
I n l e t h o s e a t t a c h m e n t The GS1-100 unit ships standard with a 1 x 2”, 2 x 2” or 1 x 3” inlet. Attach flex hose over the metal air inlet tube and tighten securely with the stainless-steel clamp.
Blower/Fan The GS1-100 unit utilizes a variable speed blower with three speed settings. Press the up and down arrow buttons to increase/decrease blower speed. A green light next to the specific speed (Low, Med, or High) will indicate speed setting. In the case of a blower failure, all 3 blower speed lights will flash. To reset the blower’s internal thermal protection, disconnect the unit momentarily from its power source and reconnect.
Page 4
Remote Interface and Connectivity Function The GS1-100 unit can be supplied with an optional interface package providing remote start/stop and filter monitoring capabilities (Part # FA228). Please see instructions below for Relay Activation/De-Activation procedures and refer to the drawing in Figure 1 for remote connections.
Page 5
Fumex reserves the right to discontinue any item and to make changes in the specifications, terms and conditions or prices at any time without prior notice. Information furnished in the specifications is believed to be accurate and reliable at time of printing, however Fumex accepts no responsibility for product use, or the effect of future design or specification changes.
Page 6
7. Now that the physical switch is activated and the unit is in the “Soft On” state, the software will need to be reprogramed via a flash drive with a configuration file and the USB port on the control board. (Contact Fumex to acquire the correct configuration file for your unit).
Page 7
7. Now that the physical switch is activated and the unit is in the “Soft On” state, the software will need to be reprogramed via a flash drive with a configuration file and the USB port on the control board. (Contact Fumex to acquire the correct configuration file for your unit).
Need help?
Do you have a question about the GS1-100 and is the answer not in the manual?
Questions and answers