Impulse Trigger Valve Lubrication - Task Force Tips Mid-Force Instructions For Safe Operation And Maintenance

11.2 IMPULSE TRIGGER VALVE LUBRICATION

1) Insert tube from BreakFree into drain
hole in pistol grip.
2) With nozzle upside down spray a 2
second burst into the pistol grip.
Holding a rag around the tube here
can help keep excess BreakFree
from the outside of the nozzle.
3) Keep nozzle upside down for at least
10 seconds to allow the BreakFree to
fl ow into the valve area.
4) Check for smooth and free operation
of the trigger. Repeat a second time if
needed.
©Copyright Task Force Tips, Inc. 2002 - 2015
If this procedure does not restore trigger operation then factory service is needed.
24 hour Technical Service and Support - 800-348-2686 - www.tft.com
25
Holding a rag around the tube here
can help keep excess BreakFree
from the outside of the nozzle.
LIN-035 June 16, 2015 Rev15