Normal Operating Sounds; Instructions; Operating - Frigidaire FDB435RFS5 Use & Care Manual

Operating Instructions
Vent
Very Important
Information—
Operating Your Dishwasher!
Normal Operating
Sounds
This dishwasher does not sound like most
dishwashers—IT'S QUIETER.
Your Precision Wash System® dishwasher
uses energy efficient motors for the wash
and drain portions of the cycle you select.
Each cycle has a series of water fills and
drains for washing and rinsing dishes. As
each cycle begins, you may–or may not–
hear the drain motor.
The next sound you will hear is the
splashing water as it enters the tub. Then
the lower arm rotates and circulates water.
This is followed by a pause and a slightly
different sound as the middle arm sprays
water. If you listen closely, you will hear the
change in sound as the wash action
switches from one arm to the other.
PLEASE BE ADVISED: If you compare
this dishwasher to previous models, you
may be surprised at what you DON'T
hear!
Getting Started
1. Load dishwasher (See Preparing and
Loading Dishes).
2. Add detergent (See Dishwasher
Dispenser & Detergents).
Read Before
(continued)
Latch
Appearance may vary from your model.
3. Add rinse aid, if needed (See Rinse Aid).
4. Select desired cycle (See Wash Cycle
Selections). The indicator will show red
when selected.
5. Turn dial clockwise to select cycle or
number of hours for delay start (available on
select models.)
6. Select desired energy OPTIONS (See
Energy Options). The indicator will show red
when selected.
7. If using DELAY START, (available on select
models) go to step number 9.
8. Run hot water faucet nearest dishwasher
until water is hot. Turn water off.
9. To start, close door to latch.
Delay Start/Status Lights
Delay Start
Allows you to delay starting the POTS & PANS
cycle up to 6 hours.
• Turn dial to select number of hours.
• Press POTS & PANS pad.
• Select desired OPTIONS.
• The DELAY START indicator light will come
on when door is closed and remain on as the
timer counts down to begin cycle.
Clean Indicator
models)
The CLEAN indicator light will come on when a
cycle is complete. To turn it off, turn dial slightly
until light goes off.
4
(available on select models)
(available on select