Moving And Storage Instructions; Accessory/Replacement Parts - MAC TOOLS MTPROG Operation And Maintenance Manual

MOVING AND STORAGE INSTRUCTIONS

WARNING! THE CLAMPS ARE LIVE AND WILL PRODUCE ARCING OR SPARKING IF THEY
COME IN CONTACT WITH EACH OTHER.
Do not store the clamps clamped together, on or around metal, or clamped to cables. Keep the clamps on the storage holders
•
when not in use.
• Store the jump starter in an upright position.
Store inside, in a cool, dry place.
•
If the jump starter is moved around the shop or transported to another location, take care to avoid/prevent damage to the cords,
•
clamps and jump starter. Failure to do so could result in personal injury or property damage.
TROUBLESHOOTING
PROBLEM
The jump starter won't jump start my car.
The jump starter won't power my 12V
device.
The battery in the jump starter won't
hold a charge.

ACCESSORY/REPLACEMENT PARTS

Please Visit:
UK: http://www.2helpu.com/MAC/GB/en-GB/
Ireland: http://www.2helpu.com/MAC/IE/en-IE/
POSSIBLE CAUSE
Clamps are not making a good
connection to the battery.
Connections are reversed.
The jump starter's battery is not
charged.
The vehicle's battery is defective.
The fuse has opened.
The 12V device is not turned on.
The jump starter's battery is not
charged.
The 12V device draws more than 15A
or has a short circuit.
The battery is bad
(will not accept a charge).
SOLUTION
Check for poor connection to battery
and frame. Make sure connection points
are clean.
Disconnect the jump starter and reverse
the clamps. The fuse will need to be
replaced.
Press the Battery Status button
on the front of the unit. The LEDs will
indicate the status of charge.
Have the battery checked.
Replace the fuse.
Turn on the 12V device.
Check the battery charge status by
pressing the Battery Status button.
Disconnect the 12V device. The internal
breaker will automatically reset after a
minute or two. Try the 12V device again.
Replace the battery.
7