Hartan ZX II plus Instructions Manual page 16

Instructions for use
Transportation lock
In order to be able to use the pram, you need to open the strap buckle 21.
For transport, fold the pram; and remember to close the buckle to prevent
it from unfolding.
Unfolding the pram
By pushing the lock buttons 4, unfold the upper section to bring the
handle in horizontal position. Pull handle 1 upwards until handle catch 2
has engaged.
WARNING! Before using the pram, make sure all catches are locked.
Folding the pram
Turn safety turn-lock 3 inward until the handle's 2 catch has released. Push
handle 1 downwards to fold the pram. By pushing the lock buttons 4, fold
the handle's upper section inward. WARNING! We recommend procee-
ding with caution when folding and unfolding the chassis, and adjusting the
backrest, as there is a risk that you do yourself an injury such as jamming
your limbs, fingers, etc.
Changing of wheels
Push the button 5 to release the retention, and pull off the wheel.
Push the wheel right to the axle's stop, and press down the button.
Make sure, all wheels are held in place properly.
Lock-type-swivel wheels
Turn the cap 6 so that the red point is visible to pre-select the straight-line
motion mode, which will be activated the moment the wheels point
in forward direction. Turn the cap 6 so that the green point is visible
to release the swivel lock. To remove the wheel, release the push-button
in the centre of the cap 6 and pull the wheel off the holding device.
To assemble the wheel, insert the fastening pin in the holding device,
and depress the push-button inside the cap, which is indicated by a
click sound.
Readjustment of hand brake
Readjust the hand brake by
means of the cable adjusting
barrel 19. A different brake
effect on the two rear wheels
can be corrected by means of
19a 8 7 8 19a
the cable adjusting barrel 19a.
12