Table of Contents
Advertisement
Bosch Motorsport
5 Troubleshooting/FAQ
My transmitter and/or receiver will not connect to the cell network indicated by a flashing
green life LED and flashing red WAN LED,
– Indication of an antenna problem. Check for correct connectivity and placement of
transmitter antenna.
My devices are connected to the network, but my transmitter is not sending data indicated
by no flashing on the data LED.
– Check that the datalogger's TX port is wired properly to LTE 65's RX port.
My devices are connected to the network and both my transmitter and receiver devices are
showing activity ("WAN" lights are flashing and not red during use), but I am unable to re-
ceive data in WDServer.
– Check that the LTE 65 receiver's TX port is wired properly to your laptop.
– Indication of a network issue on your PC. Please contact your dealer for assistance.
My telemetry file in WinDarab has no data but all lights on the LTE 65s show data is being
sent and received.
– Check in WDServer if Block/Sec and Byte/Sec are received. If Byte/Set is greater than
0 and Block/Sec is 0 this is likely an INI file. Confirm the INI file in the directory refer-
enced by WDServer matches the directory the INI file from the latest configuration
sent to the logger device.
I have another issue or my problem is not solved.
– Note the telemetry_state mode in RaceCon or WinDarab and contact your Bosch
Motorsport contact.
Telemetry System LTE 65 Manual
Troubleshooting/FAQ | 5
21 / 28
Advertisement
Table of Contents
