Advertisement
Wall Sleeve Brands:
Rear Louvers
7"
60°
Top View
5
7"
←
←
→
→
6
2
#4 General Electra/Hotpoint
1. Redirect the louvers at the back of the wall sleeve as shown
opposite. The use of pliers is recommended.
60°
2. Cut (2) 17" Tapered Spacer Blocks as shown below into two
4
pieces.
3. Install as shown with the tapered end ½" from the back of the
sleeve. This helps induce a rearward slope on the unit.
4. Attach (1) 1 ½" x 3/8" x 25" long seal in the center at the top
of the sleeve. Remove the backing paper and press into
position.
5. Attach (2) 1 ½" x 3/8" x 14" seals to the left and right sides
of the sleeve.
6. Cut the 1 ½" x 3/8" x 25" long seal to 14" long and attach it
to the vertical section of the rear grille as shown.
7. Center unit & gently slide unit into sleeve.
8. Before sliding all-the-way back, remove 2nd screw from front
on left side of unit.
9. Remove the plastic washer from the screw.
10. Screw and attach the other end of the ground wire to the
unit as shown in picture. Make sure that the toothed washer
is against the cabinet.
11. Slide the unit completely to the rear to ensure a good seal,
making sure the ground wire does not become tangled.
12. Seal & Frame the unit as described on the last page of
these instructions.
6
17"
3/4"
Tapered Spacer Block
13"
16 7/8" Deep
1"
Cut Here
Protection Paper Backing
Advertisement
