Acura 38015-TX6-A2 Installation Instructions Manual

Acura 38015-TX6-A2 Installation Instructions Manual

Remote engine start kit for 2020 ilx

Advertisement

INSTALLATION
INSTRUCTIONS
PARTS LIST
Remote Engine Start Kit
P/N 38015-TX6-A20
Remote (2)
P/N 72147-TX6-C51
Bidirectional Antenna
Transceiver
Antenna Bracket
© 2019 American Honda Motor Co., Inc. – All Rights Reserved.
Accessory
REMOTE ENGINE START KIT
P/N 38015-TX6-A20
BII13063-30 (1909)
Application
2020 ILX
(Base Model)
Screw
6 mm Flange Nut (2)
TOOLS AND SUPPLIES REQUIRED
HDS
Phillips screwdriver
10 mm Open end wrench
Small flat-tip screwdriver
Ratchet
8 mm Socket
10 mm Socket
Diagonal cutters
Tape
Shop towel
Blanket
The following tools are available through the Acura Tool
and Equipment Program. On the iN, click on Service >
Service Bay > Tool and Equipment Program, then enter
the number under "Search." Or, call 888-424-6857.
• Trim Tool Set (T/N SOJATP2014)
• Plastic Trim Tool (T/N SILTRIMTL10)
Publications No.
VERSION 1
Issue Date
SEP 2019
1 of 6
38015-TX6-A20

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 38015-TX6-A2 and is the answer not in the manual?

Questions and answers

Summary of Contents for Acura 38015-TX6-A2

  • Page 1 Tape Shop towel Transceiver Blanket The following tools are available through the Acura Tool and Equipment Program. On the iN, click on Service > Service Bay > Tool and Equipment Program, then enter the number under “Search.” Or, call 888-424-6857.
  • Page 2: Installation

    INSTALLATION Open the glove box, and remove the passenger’s dashboard trim panel. Client Information: The information in this installation PASSENGER’S instruction is intended for use only by skilled DASHBOARD TRIM technicians who have the proper tools, equipment, and PANEL training to correctly and safely add equipment to your vehicle.
  • Page 3: Climate Control Unit

    Remove the climate control unit, and disconnect the Remove the two bolts. Pull out the audio unit connector. assembly and disconnect the connectors. Remove the harness clips and remove the audio unit. CONNECTORS CLIMATE CONTROL NOTE: There is a lever lock on audio unit connectors. UNIT CLIPS (9) SCREW...
  • Page 4 Lower the tilt lever. Pull and lower the steering 10. Reconnect the negative battery cable. Then, turn the wheel. ignition to ON. Turn the steering wheel 90° counterclockwise. Using a plastic trim tool, release the retaining tab. STEERING WHEEL 2 CLIPS UPPER COLUMN COVER...
  • Page 5 13. Remove the dashboard meter visor, and disconnect 16. Slide the transceiver onto the antenna bracket as the VSA OFF switch connector. shown. DASHBOARD CLIPS (5) ANTENNA SCREW TRANSCEIVER METER VISOR BRACKET 17. Using the 6 mm screws, secure the bidirectional antenna to the antenna bracket.
  • Page 6: Remote Engine Start

    19. Using the two flange nuts, attach the antenna ENGINE REMOTE START SYSTEM REGISTRATION bracket assembly to the dashboard support. NOTE: The PCM code will be required for this procedure. Connect the i-HDS to the data link connector. ANTENNA From the HOME menu, select Immobilizer Set Up BRACKET ASSEMBLY Tool.

This manual is also suitable for:

72147-tx6-c51

Table of Contents