Advertisement
Quick Links
INSTALLATION
INSTRUCTIONS
NOTE: For additional technical information,
refer to the service information.
PARTS LIST
Remote Engine Start Kit
P/N 38015-TY2-A00
Remote (2)
Bidirectional Antenna
Transceiver
© 2019 American Honda Motor Co., Inc. – All Rights Reserved.
Accessory
REMOTE ENGINE START KIT
P/N 38015-TY2-A00
BII09104-17 (1805)
Application
2019 RLX
(TECHNOLOGY PKG)
Antenna Bracket
Screw (2)
Self-Tapping Screw (2)
TOOLS AND SUPPLIES REQUIRED
Phillips Screwdriver
8 mm Socket
Ratchet
The following tools are available through the Acura Tool
and Equipment Program. On the iN, click on Service >
Service Bay > Tool and Equipment Program, then enter
the number under "Search." Or, call 888-424-6857.
• Trim Tool Set (T/N SOJATP2014)
• Plastic Trim Tool (T/N SILTRIMTL10)
Publications No.
VERSION 1
Issue Date
MAY 2018
1 of 6
08V31-TX6-2000-91
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Acura 38015-TY2-A00
Summary of Contents for Acura 38015-TY2-A00
- Page 1 8 mm Socket Ratchet Transceiver The following tools are available through the Acura Tool and Equipment Program. On the iN, click on Service > Service Bay > Tool and Equipment Program, then enter the number under “Search.” Or, call 888-424-6857.
-
Page 2: Installation
INSTALLATION Remove the driver’s inner dashboard trim, and disconnect the connector. Client Information: The information in this installation instruction is intended for use only by skilled CONNECTOR FASTENERS (4) technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. - Page 3 Attach tape as shown. Pull out the audio-navigation unit assembly, and disconnect the audio unit connectors. DASHBOARD TAPE AUDIO-NAVIGATION UNIT ASSEMBLY FASTENERS (2) AUDIO-NAVIGATION UNIT ASSEMBLY SCREWS BOLTS 8 mm CONNECTOR LEVER LOCK LEVER LOCK CONNECTOR AUDIO UNIT CONNECTORS (12) AUDIO-NAVIGATION UNIT ASSEMBLY 3 of 6...
- Page 4 Remove the center display visor. 10. Disconnect the center display unit connectors. CENTER DISPLAY VISOR SELF-TAPPING CLIP (2) SCREW CONNECTORS (4) Remove the center display unit. Release the clips CENTER DISPLAY using the plastic trim tool, and rotate the bottom of UNIT the display up slightly while pulling away from the opening.
- Page 5 12. Slide the transceiver on the antenna bracket as 15. Locate the mounting point on the vehicle, and attach shown. the antenna bracket assembly using the two self-tapping screws. TRANSCEIVER GREEN 2-WAY PINS (2) BRACKET TRANSCEIVER ASSEMBLY CONNECTOR ANTENNA BRACKET 13.
-
Page 6: Remote Engine Start
ENGINE REMOTE START SYSTEM REGISTRATION NOTE: The PCM code will be required for this procedure. Connect the i-HDS to the data link connector. From the HOME menu, select Immobilizer Set Up Tool. From the System Selection Menu, select ONE-PUSH START, then go to Registration. From the Registration Menu, select KEYLESS ACCESS Remotes, then select 2-WAY KEYLESS SETUP.
Need help?
Do you have a question about the 38015-TY2-A00 and is the answer not in the manual?
Questions and answers