Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for JETWAY HBFBU691 Series
Summary of Contents for JETWAY HBFBU691 Series
- Page 1 QIG for HBFBU691 Series I. To Dissemble the Chassis 1. Put the system upon a stable platform with this side up, as the photo shows. Left Right 2. Locate the screws at the spots marked on the cover and both sides of the system and unscrew them one by one.
- Page 2 4.The internal structural view of the system for further intallation. II. To Install SO-DIMM to the Board Locate the SO-DIMM slot on the board. Insert the gold-figure side of the compatible SO-DIMM into the slot at a 30 degree.
- Page 3 Press down to secure the SO-DIMM to the slot. The eject tabs will lock automatically if installing direction is correct. III. To Install Wi-Fi Card 1. Locate Mini-PCIe slot on the board.Remove the marked screw and use it to lock compatible card to the slot in later installation.
- Page 4 3. Secure the card to the board by tightening up the screw to the marked spot. 4. Locate the reserved antenna holes on the rear panel. Remove the dust-proof plugs on the marked spots from the panel to install the antenna, as the following details show. 5.
- Page 5 6.And then lock the antenna head to the front side of the rear panel with the hexagonal screwnut②and tighten it up. 7. Press the metal hat on the end of the antenna string to corresponding antenna slot on the card as shown. 8.
- Page 6 Connect the external Wi-Fi receiver antenna to the antenna screw head on the rear panel. IV. To Install MSATA Card 1.Locate Mini-SATA slot on the board. 2. Remove the marked screw and use it to lock MSATA card to the slot in later installation.
- Page 7 3. Insert the gold-figure side of compatible MSATA card into the slot and press down. 4. Lock the card to the board by tightening up the screw to the marked spot.
Need help?
Do you have a question about the HBFBU691 Series and is the answer not in the manual?
Questions and answers