Safety Notes - Westfalia 87 46 87 Instruction Manual

Please note the included General Safety Notes and the following
safety notes to avoid malfunctions, damage or physical injury:

Make sure the voltage corresponds to the type label on the unit.

Persons with limited physical, sensorial or mental abilities or lack of know-
how and/or lack of knowledge are not allowed to use the unit, unless they
are supervised for their safety by a qualified person or are briefed by the
responsible person how to use the unit.

Before starting up, make sure the milling cutter (12) is firmly positioned
and secured into the collets.

Do not wear gloves while working with the machine; gloves may be caught
in the milling cutter and lead to severe injuries.

The maximum indicated limit rotation speed of the milling cutter must not
be exceeded.

Milling must always be carried out against the direction of rotation (cutter-
rotation) of the milling cutter.

The milling cutter must be running at full speed before lowering into the
work piece.

When operating the machine, take great care and always hold the router
handles firmly with both hands. Always provide for a secure footing when
working.

Beware of the reaction torque of the machine, particularly if the milling
cutter becomes jammed in the work piece.

On completion of work, allow the machine to slide back to its initial position
by releasing the retaining lever.

Make yourself familiar with your working area and be alert for possible
hazards, which you might not hear due to machine noise.

Caution: Allow for run down time of cutter after turning router off. Wait for
the machine to come to a complete stop before removing from the work
piece.

Never attempt to slow the router down with your hands.

Do not touch the cutter immediately after operation; it may be extremely
hot and could burn you.

Never stop the router by applying lateral pressure to the cutter.

Safety Notes

4